lightkorea alerón led de ala de techo pintado en negro compatible con hyundai elantra 2017 2018 2019 2020 2021 sedan

TÉRMINOS Y CONDICIONES

------------------------------------------

- El producto se trae a pedido, en un transcurso de 15 a 25 dias, si alguna restriccion de un ente gubernamental o de salud publica cambia o restringe vuelos, los pedidos pueden demorar mas tiempo.
- Precios pueden cambiar previo aviso. Depende de precio con proveedores o existencia.
- Fotos referenciales del producto, consulte no mas
- Despachamos a todo Chile con Starken.
- Productos importados de Estados Unidos, es probable que los productos electronicos trabajen en 110V y NO en 220V, podria usar un transformador, para mas informacion primero nos puedes preguntar todas las inquietudes que tengas.

- Make sure this fitsby entering your model number.
- The Design of the wing type, excellent sense of unity with the body. Cover for the entire Roof lines and simple design utilizing a sense of volume. A stylish rear spoiler which is given stability while high-speed driving. Light and strong functional products.
- ABS Material, the durability is very strong. Painted in the same process as genuine Color Code.
- Made in South Korea, ABS Material. Painted with NKA Phantom Black
- Fits to Elantra 2017 2018 Sedan
- Installation : easy Fits with 3M tapes. Description included


Fitments 2017 2018 2019 2020 2021 Elantra Sedan Installation 1. Check the components such as primer, manual, Wiring protection tape, etc. 2. Clean the surface where the spoiler will be attached. 3. Confirm the mounting position through the pre-simulation. 4. The spoiler top clip hook must be fitted. 5. Use the included primer to improve adhesion. 6. Do not remove all tape vinyl when mounting. Remove the remaining vinyl while installing it. 7. Press the product using a heating gun. 8. Please avoid new car for 3 days. LED Cable Connect 1.Use a spatula or other tool to push the wires into the glass. 2.Pull the wire tightly and insert it into the glass 3.Use the included PE foam pad to protect the wiring. 4.Open the trunk and insert the wiring through the rubber molding. 5.Remove the right cover inside the trunk and remove the wiring jack. 6.Connect with black wiring + black wiring, green wiring + red wiring. 7.Plug in the wiring jack again after finishing with the heat transfer tape.